Question 1

Can the bungee loop that holds it closed also be used to hold it open? It looks like not. View answer

Answer posted 9 years ago | Cordura Wetnotes

Question 2

is it possible to mount this plate with Hollis s-series(25,38) wings? View answer

Answer posted 9 years ago | Ultralight Travel Plate

Question 3

hi do i need to purchase an STA for this setup? View answer

Answer posted 9 years ago | Solo Donut Wing Package

Question 4

I currently have the F1 fins which have unfortunately been causing leg cramps due to their weight, could you tell me how much lighter the LT ones are please. View answer

Answer posted 9 years ago | F1 LT Fins

Question 5

How stiff are these compared to the normal F1s? How much shorter? View answer

Answer posted 9 years ago | F1 LT Fins

Question 6

How long is the webbing that comes with this kit? View answer

Answer posted 9 years ago | Harness Webbing w/ Hardware Kit

Question 7

Will this inflator work with an Oceanic Pro Tour BCD apprx 15 years old View answer

Answer posted 9 years ago | AI High Performance Power Inflator

Question 8

The book screws are capped so they dont xxxx down tight. The is quite a lot of wiggle when attached to the backplate and through the grommet. I am worried the wiggle will work the xxxx out. Am I doing something wrong? View answer

Answer posted 9 years ago | 10lb Weight Pocket System

Question 9

My measurements are 21.5"" and 16.5"". Of course this is between several sizes. Which one would you recommend? View answer

Answer posted 9 years ago | H1 5/10mm Polar Evoluted Hood w/HAV System

Question 10

Can this product be glued to a neoprene drysuits with an outer cover zip ? View answer

Answer posted 9 years ago | TIZIP Masterseal Grey Drysuit Zipper

Question 11

Do you charge the battery thru the usb?Are the batteries user replaceable? View answer

Answer posted 9 years ago | Discontinued i750TC LED Wrist Computer with USB

Question 12

I read this manifold as being a 200 bar which in PSI is around 2900. Correct? What confuses me is that it says it has a working pressure of 3500 psi. So, my question is will this manfiold work on my HP 100 (psi 3442)? View answer

Answer posted 9 years ago | Dive Rite Pro/Convertible Manifold - 3442psi - (40% O2)

Question 13

I have a 7mm that is a 12 and I am normally a 12 on this chart it appears that I would be a 10 and that does not make sense are these that stretchy (which is a good thing as I am looking for something easy to put on View answer

Answer posted 9 years ago | Nixie Women's Wetsuit

Question 14

Will this manifold work on my HP 100 (3442) because it says it has a waking pressure of 3500? View answer

Answer posted 9 years ago | Dive Rite Pro/Convertible Manifold - 3442psi - (40% O2)

Question 15

Will this weight plate work on my Hollis SMS 75? View answer

Answer posted 9 years ago | SMS 75/100 Weight Plate

Question 16

Does this product include one or two bands? View answer

Answer posted 9 years ago | XS Scuba Tank Strap with Plastic Cam Buckle - Pair

Question 17

What is the heigth of these tanks? View answer

Answer posted 9 years ago

Question 18

Is the veo 2 usb cable compatible with a Mac View answer

Answer posted 9 years ago

Question 19

2. QuestionsI wear a size 9 shoe, will size 10 Hollis Rock boot be right wearing a drysuit?What size RK3 would I need if I wear a Hollis size 10 rock boot? View answer

Answer posted 9 years ago | RK3 Rocket Fins

Question 20

Do you have a men's size small in stock? View answer

Answer posted 9 years ago | D7 PRO Cordura Front Entry

Question 21

Does this not also fit onto UN-sealed Hog D1 first stages ?Or is there another Enviro Seal Kit for the D1 ?Or is it only avail as a ""spare parts purchase""; what is the price ? View answer

Answer posted 9 years ago | D3 Environmental Seal Kit

Question 22

What is the weight of the system. View answer

Answer posted 9 years ago | SMS100 Sidemount System

Question 23

Does this bracket contour nicely against an 8"" primary tank or is it contoured for a smaller diameter primary tank? View answer

Answer posted 9 years ago | Tiger Pony Bracket

Question 24

a) where are Apeks regs manufactured? b) when ordering can I request the reg is setup with the hose on the left side? (for deco bottle on left)? View answer

Answer posted 9 years ago

Question 25

What size is it? View answer

Answer posted 9 years ago | OB Fusion Essence Womens Cut 2XS/XS

Question 26

Does it come with dust cap? View answer

Answer posted 9 years ago | HOG DIN to Yoke Adapter

Question 27

Do these come in both LH and RH configuration? View answer

Answer posted 9 years ago | TV-6200 DIN Tank Valve

Question 28

The ad say this mask comes with the go pro mount, but in the small print it say you get the mask and bag no go pro mount, can you please advise if it comes with the go pro mount View answer

Answer posted 9 years ago | Full Face Snorkeling Mask with Go Pro Mount

Question 29

is this wetsuit suitable for open water swimming such as triathlons or is it more a diving suit? View answer

Answer posted 9 years ago | 3mm Quantum Stretch Men's Full Wetsuit (Small & Large, Closeout)

Question 30

When specifying a replacement zipper length, what do I measure? Only the length of the teeth? Or the entire (longer) length of the zipper including the surrounding rubber/plastic material? View answer

Answer posted 9 years ago | TIZIP Masterseal Grey Drysuit Zipper

Question 31

Dimensions - height and width and depth it expands to?Back , is it neoprene? I want to glue to wet suit and accommodate wet notes on right leg and spool and surface marker on left. View answer

Answer posted 9 years ago | Utility Pocket - Closeout

Question 32

Can the Apeks WTX-D18 Single Cylinder Wing be easily configured with SCUBAPRO's X-TEK Pure Tek harness and backplate? View answer

Answer posted 9 years ago | WTX-D18 Single Cylinder Wing

Question 33

What is the temperature range of this under suit? View answer

Answer posted 9 years ago | Arctic Expedition One Piece

Question 34

What is the recommended torque? View answer

Answer posted 9 years ago | Hog DIN to Yoke conversion Kit

Question 35

What is the weight of the STA? View answer

Answer posted 9 years ago | 28lb BP/W System

Question 36

What O ring do I need for the valve. Where it goes against the first stage? View answer

Answer posted 9 years ago | Convertible 200 BAR DIN Valve

Question 37

I just got back from my second dive trip using my Liquidvision computer purchased Feb 2015. When it was working, it was great. The 3rd dive of 10 the transmitter heated somehow melting the silcone under the baterry frying it. 2 year warranty? View answer

Answer posted 9 years ago | KAON Air/Nitrox Dive Computer

Question 38

does the thumb lever push to release or push to lock(does the line unreel on itself if you do not hold the thumb lever down or do you have to push it down to let more out?)also how thick is the line? View answer

Answer posted 9 years ago | 270' Dive Reel

Question 39

How does the f1 lt compares with the traditional f1 in terms of weight? So far i've seen they are lighter but no numbers View answer

Answer posted 9 years ago | F1 LT Fins

Question 40

do you have a size chart for this hood? View answer

Answer posted 9 years ago | Discontinued Heat Zippered Hood

Question 41

Can this mask be used to swim laps in a pool comfortably? View answer

Answer posted 9 years ago | Full Face Snorkeling Mask with Go Pro Mount

Question 42

I have a viking pro 1000 . The wrist sleeves need to be replaced. I want to use gloves. Can I install these rings on my suit to take the place of the wrist sleeve? View answer

Answer posted 9 years ago | Rubber Pullover Dry Glove Rings

Question 43

does ths velve require any gluing or its one that needs rubber washers and xxxx in together View answer

Answer posted 9 years ago | Balanced Tinkle Valve w/Quick Disconnect

Question 44

I purchased a DIN version with the cold water option. If I want to convert it to a Yoke instead, will that break the cold water seal? View answer

Answer posted 9 years ago | Used Hog D1X - Zenith Smoke Regulator Set

Question 45

Looking for a top quality mask for prescription lens. Smaller face. Planning to purchase mask and send to a prescription mask store that can do high plus ranges View answer

Answer posted 9 years ago | Visionmaster Mask

Question 46

Years ago I had a Stebco vest with oral inflator, CO2 inflator and a ""drain valve"" on the top of the collar - convenient for releasing air w/o having to roll over. Are there any vests on the market these days with similar features? View answer

Answer posted 9 years ago | Snorkel Vest with Pocket

Question 47

Does this setup supply enough lift when diving a drysuit with thermals View answer

Answer posted 9 years ago | 28lb BP/W System

Question 48

I have a Oceanic Bioflex suit. Is this ring set bulky? The suit has a sleeve that goes over the wrist seals to protect them once you don it. My concern is whether the ring will interfere. View answer

Answer posted 9 years ago | Round Permanent Wrist System - Quick Cuff

Question 49

Approximately how many pool dives does gently used equal? View answer

Answer posted 9 years ago | USED Whites Fusion Bullet Drysuit -L/XL Red

Question 50

Can these wrists be installed on an Oceaner neoprene drysuit? In addition to these rings, silicone seals and rubber gloves, what more would i need to buy if I do the labor myself?Thanks! View answer

Answer posted 9 years ago | Oval Permanent Wrist System - QCS

Browse by Topic

Tools